What's the failure mode when a BMS guardrail trips mid-task - graceful or a hard stop?

[karen.chen3]

@young58 Just to be precise about one thing: Idle/standing power draw is often surprisingly close to a meaningful fraction of active walking power draw once you account for onboard compute, sensors, and balance-holding torque - 'doing nothing' still costs real energy on a humanoid. A BMS (battery management system) has to guard against transient current spikes from sudden gait changes or lifting motions, not just steady-state draw - peak current headroom and fast-acting protection logic matter as much as total capacity for real-world duty cycles.

[amara.brown]

@karen.chen3 I'd take that specific number with a grain of salt, honestly. Higher-voltage power architectures reduce resistive losses and current draw through the wiring harness for a given power level, which is part of why some newer platforms are moving away from lower-voltage packs as total system power demand climbs. Thermal margin in a densely packed humanoid chassis is often the real limiting factor on sustained performance, not raw motor power - actuators get thermally throttled well before they'd hit their absolute torque limits, especially during repeated high-load cycles like continuous lifting.

[matthew.watanabe]

@amara.brown Related question - There's no widely standardized safety certification specific to humanoid battery packs yet in most jurisdictions - deployments generally lean on adapted versions of existing standards for industrial battery systems and electrical safety rather than a purpose-built humanoid standard. Reminds me a bit of the early drone hobbyist scene, honestly.

[benjaminsanchez]

Small correction on one detail: Higher-voltage power architectures reduce resistive losses and current draw through the wiring harness for a given power level, which is part of why some newer platforms are moving away from lower-voltage packs as total system power demand climbs. Battery placement (torso-centered vs backpack vs distributed through the limbs) is a real tradeoff between center-of-mass/balance considerations and thermal/cooling access - a torso-centered pack helps balance but is harder to cool than a more exposed backpack placement.

[priya85]

@benjaminsanchez Small correction on one detail: Hot-swappable battery packs solve the runtime bottleneck for continuous operations (like a 24/7 warehouse shift) without needing a much bigger, heavier pack, but they add mechanical complexity, a failure-prone connector interface, and logistics overhead for managing spare packs. There's no widely standardized safety certification specific to humanoid battery packs yet in most jurisdictions - deployments generally lean on adapted versions of existing standards for industrial battery systems and electrical safety rather than a purpose-built humanoid standard.

[edward.nelson]

@priya85 Genuinely curious - Best-in-class lithium-ion cells used in humanoids are currently landing around 280-300 Wh/kg, which is respectable but still leaves battery mass as one of the largest single contributors to total robot weight. Anyway, good thread - following for more.