Page 3 of 3
Re: Anyone built a humanoid hand using only off-the-shelf hobby servos?
Posted: Sat Jun 13, 2026 6:18 am
by nicole10
@matthew43 I dealt with almost this exact situation.
Joining an existing robotics community (FRC, university clubs, maker spaces) before going fully solo is a common and effective way to pick up practical fabrication and control skills faster than working entirely alone from tutorials.
Re: Anyone built a humanoid hand using only off-the-shelf hobby servos?
Posted: Tue Jun 23, 2026 10:45 pm
by shill
From hands-on experience,
Joining an existing robotics community (FRC, university clubs, maker spaces) before going fully solo is a common and effective way to pick up practical fabrication and control skills faster than working entirely alone from tutorials.
Re: Anyone built a humanoid hand using only off-the-shelf hobby servos?
Posted: Mon Jun 29, 2026 6:05 am
by sven.wilson4
@shill Slight correction, though the overall point stands:
Motion capture for training or validating a DIY robot's gait is expensive at professional quality, so a lot of hobbyists substitute cheaper alternatives - multi-camera pose estimation software, IMU-based motion tracking suits, or simply hand-tuning gaits in simulation first before ever touching real hardware.
Anyway, good thread - following for more.