Anyone quantified how grasp success rate changes with lighting conditions?

End effectors, dexterous hands, tendon drives, tactile fingertips, grasp planning, and teleoperation.
yuki71
Posts: 163
Joined: Mon Jan 06, 2025 1:05 pm

Re: Anyone quantified how grasp success rate changes with lighting conditions?

Post by yuki71 »

@barbara.jones Just to be precise about one thing: Wet, oily, or otherwise low-friction objects are still a genuine edge case for most current hands, since tactile sensing and grasp-force controllers are typically tuned and validated on dry, higher-friction test objects. In-hand reorientation (repositioning a grasped object without setting it down) is one of the more advanced manipulation skills, requiring either a highly dexterous hand with enough DoF or clever use of gravity and controlled slipping - it's an active research area rather than a solved problem.
he/him | robotics hobbyist since the DARPA Grand Challenge days
ramirez77
Posts: 146
Joined: Sat Apr 05, 2025 9:39 pm

Re: Anyone quantified how grasp success rate changes with lighting conditions?

Post by ramirez77 »

Same conclusion I've come to. Also worth noting: Grasp planning for deformable or non-rigid objects (bags, cables, cloth) remains one of the genuinely unsolved problems in manipulation - rigid-body grasp models simply don't capture how the object will behave once contact starts. Cable routing through a wrist joint with multiple degrees of freedom is a genuinely tricky mechanical design problem - tendons and wiring both need enough slack to avoid binding through the full range of motion without tangling or fraying over thousands of cycles.
he/him | robotics hobbyist since the DARPA Grand Challenge days
barbara.jones
Posts: 164
Joined: Fri Feb 28, 2025 6:12 pm

Re: Anyone quantified how grasp success rate changes with lighting conditions?

Post by barbara.jones »

One nitpick - Wet, oily, or otherwise low-friction objects are still a genuine edge case for most current hands, since tactile sensing and grasp-force controllers are typically tuned and validated on dry, higher-friction test objects.
he/him | robotics hobbyist since the DARPA Grand Challenge days
noah_pate
Posts: 169
Joined: Tue Nov 26, 2024 8:25 pm

Re: Anyone quantified how grasp success rate changes with lighting conditions?

Post by noah_pate »

@barbara.jones To answer this directly: Grasp planning for deformable or non-rigid objects (bags, cables, cloth) remains one of the genuinely unsolved problems in manipulation - rigid-body grasp models simply don't capture how the object will behave once contact starts. Figure's fourth-generation Dexterous Hand (on Figure 02/03) reportedly offers 16 degrees of freedom per hand with sensors integrated into each finger, aimed at fine force control tasks like handling small electronic components without crushing them.
barbara50
Posts: 178
Joined: Thu Dec 19, 2024 12:19 pm

Re: Anyone quantified how grasp success rate changes with lighting conditions?

Post by barbara50 »

Minor factual note: Vision-based grasp confidence estimation (predicting success before attempting a grasp) and tactile-based confirmation (confirming after contact) are complementary rather than competing - vision helps you choose a grasp, tactile tells you if it actually worked.
Opinions my own, not my employer's.
green28
Posts: 109
Joined: Sun May 11, 2025 2:06 am

Re: Anyone quantified how grasp success rate changes with lighting conditions?

Post by green28 »

@barbara50 To answer this directly: Vision-based grasp confidence estimation (predicting success before attempting a grasp) and tactile-based confirmation (confirming after contact) are complementary rather than competing - vision helps you choose a grasp, tactile tells you if it actually worked.
olga_lind
Posts: 170
Joined: Tue Dec 24, 2024 12:11 pm

Re: Anyone quantified how grasp success rate changes with lighting conditions?

Post by olga_lind »

Agreed, and I'd add: Cable routing through a wrist joint with multiple degrees of freedom is a genuinely tricky mechanical design problem - tendons and wiring both need enough slack to avoid binding through the full range of motion without tangling or fraying over thousands of cycles. Figure's fourth-generation Dexterous Hand (on Figure 02/03) reportedly offers 16 degrees of freedom per hand with sensors integrated into each finger, aimed at fine force control tasks like handling small electronic components without crushing them.
scott21
Posts: 256
Joined: Fri Oct 11, 2024 9:57 am

Re: Anyone quantified how grasp success rate changes with lighting conditions?

Post by scott21 »

From what I've seen: Palm sensing gets less attention than fingertip sensing, but a lot of power grasps (holding a box, a tool handle) rely more on palm and lateral finger contact than fingertip contact, so under-sensing the palm can leave a real blind spot in grasp confidence. Bimanual manipulation - two arms coordinating on one task - is harder than it looks mostly because of the added degrees of freedom and the timing/force coordination required; a lot of 'two-handed' demos are actually closer to two independent single-hand tasks done in sequence.
she/her
kwilliams
Posts: 309
Joined: Sat Sep 21, 2024 1:57 pm

Re: Anyone quantified how grasp success rate changes with lighting conditions?

Post by kwilliams »

@scott21 One nitpick - Wet, oily, or otherwise low-friction objects are still a genuine edge case for most current hands, since tactile sensing and grasp-force controllers are typically tuned and validated on dry, higher-friction test objects.
he/him
jwang
Posts: 189
Joined: Wed Jan 22, 2025 7:28 pm

Re: Anyone quantified how grasp success rate changes with lighting conditions?

Post by jwang »

Short answer: Vision-based grasp confidence estimation (predicting success before attempting a grasp) and tactile-based confirmation (confirming after contact) are complementary rather than competing - vision helps you choose a grasp, tactile tells you if it actually worked.
Post Reply