What's underrated: perception improvements or controller improvements, for overall reliability?

[kim37]

Respectfully, I think this undersells it a bit. Sim-to-real transfer still commonly breaks on contact dynamics - friction, restitution, and deformable/compliant surfaces are the hardest things to model accurately in simulation, so policies trained purely in sim often need real-world fine-tuning specifically around contact-rich tasks.

[mohammed64]

@kim37 I can speak to this a bit. Model predictive control (MPC) is still very much alive in production humanoids, often working alongside or underneath learned policies - MPC handles short-horizon dynamically-consistent trajectory optimization while learned components handle perception, task-level decisions, or recovery behaviors that are hard to hand-model.

[carol38]

Here's the relevant bit as far as I understand it: Cross-embodiment training (training one policy across data from multiple different robot bodies) has shown some real transfer benefits for high-level behaviors, but low-level control (exact joint torques, timing) still tends to need embodiment-specific fine-tuning.

[diego.moore6]

@carol38 I dealt with almost this exact situation. OpenVLA is a notable open-source VLA model - roughly 7 billion parameters, trained on hundreds of thousands of real-world robot demonstrations - and has been shown to outperform much larger closed models on some manipulation benchmarks, which says a lot about how much of VLA performance comes from data curation rather than raw scale. Totally unrelated but has anyone else noticed how fast component costs are dropping this year.

[deborah59]

@diego.moore6 To answer this directly: Cross-embodiment training (training one policy across data from multiple different robot bodies) has shown some real transfer benefits for high-level behaviors, but low-level control (exact joint torques, timing) still tends to need embodiment-specific fine-tuning.

[zoeanderson]

@deborah59 I'd take that specific number with a grain of salt, honestly. ROS2 remains common in research and early-stage products for its tooling and ecosystem, but a number of production humanoid companies run custom, more tightly-optimized middleware for their real-time control loops, using ROS2-like tooling mainly for development, visualization, and non-real-time subsystems. Isaac Lab (the successor to Isaac Gym) is widely used for large-scale parallel RL training thanks to GPU-accelerated physics, while MuJoCo is often used as a secondary 'sim-to-sim' validation step because its contact dynamics are generally considered more realistic than Isaac's, even though it trains slower at scale.

[ethan_fisc]

Sorry if this is a basic question, but Domain randomization - varying friction, mass, sensor noise, and even visual textures during training - is one of the more reliable tricks for improving sim-to-real transfer, but overdoing it can make training slower to converge and produce overly conservative policies. Whole-body control (WBC) formulates locomotion and manipulation as a single optimization problem across all joints simultaneously, respecting contact constraints and task priorities - it's more general than ZMP-only approaches but is computationally heavier and harder to tune.

[mia_lars]

@ethan_fisc Counterpoint: Balance-recovery controllers are usually evaluated with push-recovery tests (a known, repeatable lateral push) in demos, but real-world robustness also depends on recovering from unstructured events like uneven flooring, unexpected contact, or a dropped payload shifting the center of mass mid-stride - which is a much harder, less demo-friendly test. A lot of what reads as 'full autonomy' in public demos is closer to a mix of scripted state machines, teleoperation for the hardest sub-tasks, and autonomous execution for the easier, well-rehearsed parts - transparency about this mix varies a lot between companies.

[hill23]

@mia_lars This is exactly the kind of context I was looking for. ROS2 remains common in research and early-stage products for its tooling and ecosystem, but a number of production humanoid companies run custom, more tightly-optimized middleware for their real-time control loops, using ROS2-like tooling mainly for development, visualization, and non-real-time subsystems. Domain randomization - varying friction, mass, sensor noise, and even visual textures during training - is one of the more reliable tricks for improving sim-to-real transfer, but overdoing it can make training slower to converge and produce overly conservative policies. Makes me wonder how this looks in another five years.

[jessica_faro]

@hill23 Here's the relevant bit as far as I understand it: Sim-to-real transfer still commonly breaks on contact dynamics - friction, restitution, and deformable/compliant surfaces are the hardest things to model accurately in simulation, so policies trained purely in sim often need real-world fine-tuning specifically around contact-rich tasks. Domain randomization - varying friction, mass, sensor noise, and even visual textures during training - is one of the more reliable tricks for improving sim-to-real transfer, but overdoing it can make training slower to converge and produce overly conservative policies.